Description

MTX designs their amps for reliability. All internal wiring is as short as possible, for the purest reproduction with low noise. An anodized aluminum heat sink pulls the heat right out of this amp, so it’ll keep on rockin’ even when you push your system hard. You can bridge the amp to 2-channel operation to drive two subs with 180 watts each, and you can use the built-in frequency filters to tailor the amp to the job at hand, whether it’s powering speakers or subs.

-60 watts RMS x 4 at 4 ohms (90 watts RMS x 4 at 2 ohms)
-180 watts RMS x 2 bridged output at 4 ohms (4-ohm stable in bridged mode)
-PWM MOSFET switching power supply
-Intelligent Surface Mount Technology for cleaner sound and greater reliability
-variable high-pass/low-pass crossovers (40-400 Hz at 12 dB/octave)
-preamp and speaker-level inputs
-4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
-fuse rating: 30A x 2
-14″W x 2-1/16″H x 7-1/8″D